Chrysler 200 I (2011-2014) fuse box diagrams & schemes (2024)

Years of production: 2011 2012 2013 2014

Table of contents

  1. Integrated Power Module fuses
  2. Information about the model

Related diagrams & schemes

  • Chrysler 200 II (2015-2017) Fuse box

Integrated Power Module fuses

Chrysler 200 I (2011-2014) fuse box diagrams & schemes (1)

Integrated Power Module

The Integrated Power Module is located in the enginecompartment near the air cleaner assembly. This centercontains cartridge fuses and mini fuses. A label thatidentifies each component may be printed on the insideof the cover. Refer to the graphic below for FUSES/TIPMlocation.

When installing the Integrated Power Modulecover, it is important to ensure the cover is properlypositioned and fully latched. Failure to do somay allow water to get into the Integrated PowerModule, and possibly result in an electrical systemfailure.

When replacing a blown fuse, it is important touse only a fuse having the correct amperage rating.The use of a fuse with a rating other than indicatedmay result in a dangerous electrical system overload.If a properly rated fuse continues to blow, itindicates a problem in the circuit that must becorrected.

CavityCartridge FuseMini FuseDescription
140 Amp Green-Power Top Module– If Equipped
2-20 Amp YellowBrake Vacuum Pump
3-10 Amp RedCenter High Mounted Stop Light (CHMSL)/Brake Switch
4-10 Amp RedIgnition Switch
5-20 Amp YellowTrailer Tow – If Equipped
6-10 Amp RedPower Mirror Switch/Climate Controls
7-30 Amp GreenIgnition OffDraw (IOD) Sense 1
8-30 Amp GreenIgnition Off Draw (IOD) Sense 2
940 Amp Green-Battery Feed – Power Seats – If Equipped
10-20 Amp YellowInstrument Panel/ Power Locks/Interior Lights
11-15 Amp Lt BlueSelectable Power Outlet (Inside Center Arm Rest)
12-
13-20 Amp YellowIgnition/Cigar Lighter
14-10 Amp RedInstrument Panel
1540 Amp Green-Radiator Fan Relay
16-15 Amp Lt. BlueSunroof – If Equipped
17-10 Amp RedWireless Control Module (WCM)/ Clock/Steering Control Module (SCM)
1840 Amp Green-Auto Shutdown (ASD) Relay
19-20 Amp YellowAudio Amplifier – If Equipped
20-15 Amp Lt. BlueRadio
21-10 Amp RedSiren – If Equipped
22-10 Amp RedIgnition Run – Climate Controls/Hot Cupholder – If Equipped
23-15 Amp Lt. BlueAuto Shutdown (ASD) Relay 3
24-25 Amp NaturalSunroof – If Equipped
25-10 Amp RedIgnition Run - Heated Mirrors - If Equipped
26-15 Amp Lt. BlueAuto Shutdown (ASD) Relay 2
27-10 Amp RedIgnition Run - Occupant Classification Module (OCM)/ Occupant Restraint Controller (ORC)
28-10 Amp RedIgnition Run - Occupant Classification Module (OCM)/ Occupant Restraint Controller (ORC)
29-— Hot Car (No Fuse Required)
30-20 Amp YellowIgnition Run – Heated Seats – If Equipped
31-— Spare
3230 Amp Pink-AutoShutdown (ASD) Relay 1
33-10 Amp RedSwitch Bank/ DiagnosticLink Connector/ Powertrain Control Module (PCM)
3430 Amp Pink-Anti-Lock Brakes (ABS) Module – If Equipped/Electronic Stability Control (ESC) Module – If Equipped
3540 Amp Green-Anti-Lock Brakes (ABS) Module – If Equipped/Electronic Stability Control (ESC) Module – If Equipped
3630 Amp Pink-Passenger Door Module (PDM)/Driver Door Module (DDM)
37-25 Amp NaturalPower Top Module – If Equipped

Information about the model

There was a time when people preferred a mid-size sedan for their families. It providesoptimal performance as well as luxury to the people. Chrysler launched its mid-size sedanthat is convertible with some redesign. In the year 2011, it launched a sedan equipped withpower, an upscale interior, better handling, and maximum comfort.This four-door family sedan or two-door convertible is equipped with bulk loads offeatures. It specifically addresses the need for those who want all the equipment andoptimal performance levels. The specified price of Chrysler 200 makes it a hit in itssegment. If one is looking for some innovative features and adequate equipment, then thisis a great alternative.

Chrysler 200: First Generation

Chrysler 200 contains all the features related to safety, entertainment, and performance. Atthat time, this car was equipped with top-notch features such as USB connectivity, LEDcabin lighting, motorized heated leather seats, a touchscreen navigation system, hard-driveaudio storage, and some other ones.

From a technical point of view, 200 was offered with different variants that offerednumerous ranges. One can opt for a two-door convertible or four-door sedan. It also has aunique grade of interiors, which provides a luxurious feel to the customers. The engine of200 is a 2.4 liter four-cylinder unit with 173 horsepower that provides optimalperformance. It comes with a four-speed automatic transmission and also with 6-speedautomatic transmission.

This was a value for money vehicles due to its overall looks. Apart from that, it was capableof providing a comfortable ride. With the smooth performance of the engine, the Chrysler200 achieves the top-notch position in the segment. In addition to that, the fuel efficiency isalso a plus point of this car. Those who are concerned about the boot space can getmaximum cargo volume after the seats get folded.

All Chrysler 200 I info & diagrams provided on this site are provided for general information purpose only. Actual Chrysler 200 I (2011-2014) diagrams & schemes (fuse box diagrams & layouts, location diagrams, wiring diagrams etc.) may vary depend on the model version.

Comments (14):

~Jerry 03-02-2019
Have chrysler 200 2013 checked fuses my menu doesn't come on where its shows tires pressure miles to go on gas system check not even my gas gauge moves

~Keith 07-06-2019
What color is the fuse for Chrysler 200 for the horn

~ralphcaddy 29-08-2020
my back brake light thats in my rear window is not working can you tell me which fuse operate it

~Thomas meyer 16-09-2020
What would cause a Chrysler 200 to shut down while driving down the roadI talked to a guy who saidHe had the same problems and he said it was an ignition fuse. Is this true give me your feed back

[emailprotected] 24-03-2021
Is there a fuse for the window washer pump?

~Tyree jackson 14-04-2021
Which fuse is for the horn? My horn is going off randomly

[emailprotected] 01-10-2021
The horn sounds automatically at anytime. Is there a fuse to repair the problem

~Steve Register 22-10-2021
Car starts runs about ,1 minute then shuts down.

~Steve Register 22-10-2021
Car starts runs about ,1 minute then shuts down. No power to fuses 23,25,26 and relay 32

~Scott 09-12-2021
After doing a volt meter test to find the parasitic draw on my Chrysler 200 fuse number 14 is the culprit !witch is the instrument panel ! Does that mean the entire panel must be replaced or can there be a route cause please help

~Bob 08-01-2022
What colour fuse is windshield washer

~Sybrand 11-08-2022
My 2012 Chrysler 200, on the instrument pannel reads "Left front turn signal not working" when it's turned on and the same for the right side. I cant find a fuse for it. Any idee what can be the cause? Thanks

~Gustavo 17-08-2022
Try to start but dost want to new battery an starter

~Sharon 13-03-2023
What fuse is for my 2011 Chrysler 200. It has been blowing low but now no sound. Thanks for your help!

Add comment
Chrysler 200 I (2011-2014) fuse box diagrams & schemes (2024)

FAQs

Where is the fuse layout? ›

The main fuse box is typically located under the hood, while secondary fuse panels might be inside the car, often near the dashboard or steering wheel. The fuse's wire conductor breaks when the current exceeds the ampere limit, which manufacturers usually define along with different color codes on each fuse.

What are the different fuses in a fuse box? ›

Your fuse box will have two sets of fuses. At the bottom will be 15-amp and 20-amp screw-in fuses with glass faces that are exposed and visible. These fuses will service branch light circuits and outlet circuits. At the top will be 30-amp or 40-amp cartridge main fuses for ovens, laundry rooms, or stoves.

How many fuse boxes does a 2013 Chrysler 200 have? ›

There 2 fuse boxes in a 2013 Chrysler 200. Only shows the one under hood. Change fuse under the hood.

How do you tell which fuse is which? ›

Generally the manufacturer's brand name and the actual part number should be enough to identify the right fuse.

Where is the secondary engine compartment fuse box? ›

The secondary under-hood fuse box is next to the battery. To open it, push the tabs as shown. If something electrical in your vehicle stops working, check for a blown fuse first. Determine from the chart on pages and , or the diagram on the fuse box lid, which fuse or fuses control that device.

How do you diagnose a bad fuse box? ›

Common Fusebox Problems To Look Out For
  1. Tripped Circuit Breakers. Signs: Frequent circuit breaker trips resulting in power outages in specific areas of your home. ...
  2. Flickering or Dimming Lights. ...
  3. Continuously Tripping Ground Fault Circuit Interrupters (GFCIs) ...
  4. Buzzing or Sizzling Sounds. ...
  5. Old or Outdated Fuseboxes.
Aug 10, 2024

Which wire is there in fuse? ›

Generally, fuse wire is made of an alloy of lead and tin because its resistivity is high and melting point is low.

What are the parts of a fuse box? ›

Parts of the Fuse Box
  • Main switch: This allows you to turn off the power to your entire house.
  • Residual current devices: These are switches that trip a circuit when dangerous conditions are present, instantly disconnecting the electricity in the process.
  • Fuses: Fuse boxes have a row of fuses lined up side by side.

Where is the fuse for a Chrysler 200? ›

The main fuses for your vehicle are located in the engine compartment fuse box.

What is the box where fuses are? ›

Fuse boxes are metal boxes that store fuses, which is an electrical safety measure that will shut-off power when the power is beyond that fuses ability to contain the power. Fuse boxes are very simple, yet intelligently designs devices that work by powering the electrical current through a piece of metal strip.

Where is the fuse board located? ›

In many homes, especially older ones, the fuse box is often located in the basem*nt, under the stairs or a utility room. It might be mounted on a wall or placed on a freestanding panel.

What is the placement of fuses? ›

The best place to install a fuse in a grounded power system is on the ungrounded conductor path to the load. That way, when the fuse blows there will only be the grounded (safe) conductor still connected to the load, making it safer for people to be around.

Top Articles
Latest Posts
Article information

Author: Terrell Hackett

Last Updated:

Views: 5409

Rating: 4.1 / 5 (52 voted)

Reviews: 91% of readers found this page helpful

Author information

Name: Terrell Hackett

Birthday: 1992-03-17

Address: Suite 453 459 Gibson Squares, East Adriane, AK 71925-5692

Phone: +21811810803470

Job: Chief Representative

Hobby: Board games, Rock climbing, Ghost hunting, Origami, Kabaddi, Mushroom hunting, Gaming

Introduction: My name is Terrell Hackett, I am a gleaming, brainy, courageous, helpful, healthy, cooperative, graceful person who loves writing and wants to share my knowledge and understanding with you.